Joining of Heat Pipes and Vapor Chambers

Heat pipes and vapor chambers are used to transfer and/or spread heat from concentrated heat sources such as high brightness light emitting diodes (LEDs) and high computing speed CPUs. These active thermal management devices are enclosures/tubes that have porous wick materials lining the walls that provide condensation surfaces and small connected pores that via capillary force, transfer condensed fluids that were originally vaporized at heat source surfaces. When the vapor is transported via convection to the cooler surface to condense, the fluid is then channeled back to the heat source surfaces in a continuous cycle, in effect pumping the heat out of the package without using external power surfaces. Figure 1 illustrates a vapor chamber used to cool a mounted CPU.

Thermal management is critical in the life and performance of such electronic components that all employ a variety of thermal interface materials (TIMs). With increased power and speed, the polymer-based TIMs being used today are limiting and metal bonding with solders is growing in application. Conventional Sn-Ag soldering temperatures can overheat the thermal fluids in heat pipes and chambers while Indium (In) solders are expensive and do not bond as well as active solders. Responding to this need, engineers at S-Bond^® Technologies have announced its latest alloy, S-Bond^® 140 as an effective TIM for bonding CPUs or LEDS to heat pipes and vapor chambers.  The Bi-Sn-Ag-Ti alloy can wet and join to all metals including aluminum and to most ceramics and glasses.  S-Bond^® 140 is lead free, does not require plating and flux thus keeping electronic and LED packages clean.

Figure 2 illustrates a high brightness LED array that has been bonded to a Ni-plated copper vapor chamber with S-Bond 140 solder. This technique provides a high strength and high thermal conductivity metallic solder bond. Figure 3 is another example showing S-Bond 140 solder bonding copper heat pipe tubes (water as the phase change fluid) into aluminum slots to enhance the cooling from the heat pipe to the aluminum package base without plating and flux.. Normally when soldering heat pipes over 200°C, the water in the heat pipe goes to vapor and the resultant pressure distends/distorts the thin copper tube walls. Lower temperature metallic solders, such as S-Bond 140.

Contact us for more information and to order our S-Bond products.